How To Trim A 360 Lace Frontal Wig

mslynnhair11447 · 2021-04-07 06:28:36

360 Wigs can give your comfortable and natural feeling when you wear them.They also allow the wearers to personalize the look of the lace wig, including trimming the hair itself into a particular style and trimming the hairline of the wig's lace to make it fit the user perfectly.

If you don't know how to cut the 360 Lace Wig , don't worry, this blog is to teach you how to cut the lace on a lace front wig.

How To Trim A 360 Lace Frontal Wig ?
Step 1: Cut the corner close to ear off
Braid hair in cornrows or wrap hair around the head with a brush or comb. Braiding or wrapping hair allows the wig to sit on your head evenly. Cover the hair with a wig cap to avoid aggravation from the wig base, causing further breakage to your hair. The wig base can rub against thinner hair strands around your head which can cause hair breakage.

Step 2:Adjust the wig until to fits your head.
Place the 100 virgin human hair wig on your head. Adjust the straps at back of the front lace wig until it completely fits your head. Brush the hair with a wig brush to detangle.

Step 3:Secure the lace on the forehead.
Secure the lace so that it rests flat on the forehead. Make sure the lace base is even with your natural hairline.Place a ruler against the lace in a vertical position. Start on the left side of the lace where the front lace wig hair and lace meet. Place a small dot with a pen at the 1/8 inch or 1/4 inch of the lace front. The extra length is left to prevent loss of the hairline if the lace begins to fray and needs to be cut off.

Step 4:Connect the dots with a line across the wig.
Repeat this step above until you reach the end of the lace. Connect the dots with a line across the front lace wig.

Step 5:Take the wig off.
Take the wig off. Remove loose strands from the pre plucked lace front wig. Lay the front lace wig down on the table.

Step 6: Cut lace into sections
Cut the lace with scissors along the line you created with the dots. Do not leave pen marks on the lace.

Step 6: Glue the leftover lace on your head. Use adhesive hair glue to glue the leftover lace onto your head. Cover with make-up if needed.

Trim the sides of the deep invisible part lace front wig. It is necessary to cut the lace all the way back on the sides since this part is not as visible as the forehead area.

Double check the trimmed lace to ensure that there are no jagged edges. Make sure that the lace of the wig is cut completely even, especially around the forehead area.

I hope you have found this guide useful. If you need any more help just let us know either by visit www.mslynnhair.com